Tycon Wireless EZ-Bridge 2.4GHz 802.11gn 100MB Point to Point Bridge

The EZ-Bridge LT2+ is a high-power 25dBm (316mW) outdoor wireless bridge system operating in the 2.4GHz unlicensed frequency spectrum, providing real-world throughput of up to 100 Mb/sec. It complies with the 802.11gn standards to ensure interoperability. The EZ-Bridge LT2+ creates a transparent wireless bridge between two networks up to 3 miles apart with a good line of sight. It supports VOIP, VPN, multiple MAC addresses, and DHCP across the wireless link. It is the perfect plug-and-play solution for connecting networks in two or more buildings, internet access sharing, remote video surveillance, or remote network access. Multiple EZ-Bridge LT2+ units can be connected in a mesh configuration to interconnect more than two sites.

With its password verification, MAC address authentication, SSID suppression, and advanced WPA encryption, the system provides the best available wireless data security.

Installation is a snap because of the plug-and-play features built into the system. Just install the antennas and plug in the power inserters. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done through the built-in web interface from any point on either side of the high-power network. No drivers or software need to be loaded onto the computer.

The EZ-Bridge LT2+ comes complete with all the electronics that are needed for a point-to-point wireless network bridge installation, including two powerful 14dBi 802.11gn MIMO antennas with built-in high power electronics, Bracket Kits that accommodate pole or wall mounting and Cat5e rated 24V POE (Power Over Ethernet) power inserters. The customer must supply CAT5 cabling between the power inserter and the antenna and between the power inserter and his computer, router, or switch.

• High Power Electronics and a powerful antenna
• True Plug and Play
• 64 and 128bit WEP, WPA and WPA2 Encryption
• Web-based configuration
• Power over Ethernet
• Layer 2 Transparent Bridge

• Operation up to 3 miles with good line of sight and up to 100 Mbps real world throughput
• No driver needed. Pre-configured at the factory for automatic peer to peer communications
• Most powerful data security available
• Remotely change device configuration or update firmware from anywhere on the network
• Antennas can be mounted up to 100meter (300’) from the power inserter
• Appears to network devices as if an Ethernet cable has been installed between the 2 network nodes. Passes DHCP, VOIP Packets, VLAN Packets and supports multiple MAC addresses